Specifications

Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
• G Turn and Lane Change Signals. See Turn and
Lane-Change Signals on page 3-8.
• 3 Headlamp High/Low-Beam Changer. See
Headlamp High/Low-Beam Changer on page 3-9.
• Flash-to-Pass. See Flash-to-Pass on page 3-9.
• N Windshield Wipers. See Windshield Wipers on
page 3-9.
• L Windshield Washer. See Windshield Washer
on page 3-10.
For information on the headlamps, see Exterior Lamps
on page 3-14.
Turn and Lane-Change Signals
The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will return
automatically.
An arrow on the instrument
panel cluster will flash in
the direction of the
turn or lane change.
To signal a lane change, raise or lower the lever until
the arrow starts to flash. Hold it there until you complete
your lane change. The lever will return by itself when
you release it. If you momentarily press and release
the lever, the turn signal will flash three times.
If the arrow flashes faster than normal as you signal a
turn or a lane change, a signal bulb may be burned
out and other drivers will not see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows do not go on at all when you
signal a turn, check for burned-out bulbs and then check
the fuse. See Fuses and Circuit Breakers on page 5-100.
3-8