Owner`s manual

Black plate (8,1)
Chevrolet Corvette Navigation System - 2011
8 Infotainment System
Storing Radio Station Presets
To set preset radio stations:
1. Press the power/volume knob to
turn the system on.
2. Press SRCE and select the
desired band (AM, FM1, FM2,
XM1, or XM2 (if equipped)).
3. Use
O SEEK arrows to tune to
the desired station.
4. Press and hold one of the six
preset screen buttons, at the
bottom of the screen, until a
beep is heard or the station
is displayed on the selected
preset button.
5. Repeat the steps for each
preset.
See “Preset Station Menu” under
AM-FM Radio on page 14 for more
information.
Setting the Clock
To set the time:
1. Press the power/volume knob to
turn the system on.
2. Press and hold the time display
in the upper right corner of any
screen.
3. Select the 12H or 24H screen
button to display the time in
standard or military time.
4. Press and hold the Hour and
Min. (minute) arrow buttons to
increase or to decrease the time.
5. Select the correct time zone
screen button.
6. Select the Daylight Saving Time
screen button, if necessary.
The radio uses the GPS satellite to
set the time. The vehicle needs to
be in an open area to receive the
signal. See “Clock” under AM-FM
Radio on page 14 for more
information.
Setting the Region, Entering
an Address and Point of
Interest, and Storing a Home
Destination and Preset
Destinations
Before entering an Address,
Point of Interest, Home, or Preset
Destination, select the correct
region that contains the final
destination. The vehicle must
be stopped to do this operation.
Setting the Region
To set the region:
1. If the radio is already on with
a map disc inserted, skip to
Step 5.
2. Press the power/volume knob to
turn the system on.
3. Insert the DVD map disc.
See “Installing the Map DVD”
under Maps on page 73 for
more information.
4. A Caution may appear.
Press Agree to proceed.