Technical data

Vehicle care 173
5. Rotate the wrench checking the
correct position of jack until wheel
is clear of the ground.
6. Unscrew the wheel nuts.
7. Change the wheel.
8. Screw on the wheel nuts.
9. Lower vehicle.
10. Install the wheel wrench ensuring
that it locates securely and tighten
each nut in a crosswise
sequence. Tightening torque is
120 Nm.
11. Align the valve hole in the wheel
cover with the tyre valve before
installing.
Install wheel nut caps.
12. Stow the replaced wheel and the
vehicle tools. To prevent the
rattling noise, turn screw head
until the top and bottom of the jack
are completely squeezed to the
toolbox after returning the jack to
its original position. At this time,
make sure that jack has some
clearance to any vehicle tool.
Tools 3 165.
13. Check the tyre pressure of the
installed tyre and also the wheel
nut torque as soon as possible.
Have the defective tyre renewed or
repaired.
Spare wheel
Compact spare wheel
The spare wheel can be classified as
a temporary spare wheel depending
on the size compared to the other
mounted wheels and country
regulations.
The spare wheel has a steel rim.
Use of a spare wheel that is smaller
than the other wheels or together with
winter tyres could affect driveability.
Have the defective tyre replaced as
soon as possible.
The spare wheel is located in the load
compartment beneath the floor
covering. It is secured in the recess
with a wing nut.
The spare wheel well is not designed
for all permitted tyre sizes. If a wheel
wider than the spare must be stowed
in the spare wheel well after changing
wheels, the floor cover can be placed
on the projecting wheel.