Technical data

Vehicle care 159
4. Rotate bulb holder anti-clockwise.
5. Remove bulb holder. Push bulb
into socket slightly, rotate anti-
clockwise, remove and renew
bulb.
6. Insert bulb holder into the tail light
assembly and screw into place.
Connect wiring plug. Install tail
light assembly in body and tighten
screws. Close covers and
engage.
7. Switch on ignition, operate and
check all lights.
Side turn signal lights
1. Push light towards the back of the
vehicle and remove.
2. Rotate bulb holder anti-clockwise.
3. Pull bulb out of the bulb holder and
renew.
4. Reinstall in reverse order.
Centre high-mounted
brake light
<Bulb type>
1. Open the tailgate.
2. Remove the two screws and the
lamp housing. Disconnect the
wiring harness connector before
removing the lamp housing.
3. Remove the two screws and the
reflector assembly.
4. Remove the bulb by pulling it
straight out of the bulb holder.
5. Install a new bulb.
6. Reinstall the lamp housing.
<LED type>
Have bulbs replaced by a workshop.