Specifications

ENGINE COOLANT HOT
If the cooling system temperature gets hot, this message
will appear in the DIC. Turn off the air conditioning. If the
message is still on, or if the engine coolant temperature
gage continues to rise, pull the vehicle over when it is
safe to do so. See Engine Coolant Temperature Gage on
page 3-38 for more information. Stop the vehicle and let
the engine idle in PARK (P) for a few minutes to allow the
coolant to reach a safe temperature. This message will
clear when the coolant temperature drops to a safe
operating temperature. Pressing any of the four DIC
buttons will clear the message from the DIC display. If
your vehicle does not have the four DIC buttons, pressing
the trip odometer reset stem will clear the message from
the DIC display.
ENGINE OVERHEATED
Notice: If you drive your vehicle while the engine is
overheating, severe engine damage may occur. If an
overheat warning appears on the instrument panel
cluster and/or DIC, stop the vehicle as soon as
possible. Do not increase the engine speed above
normal idling speed. See Engine Overheating on
page 5-30 for more information.
If the engine cooling system reaches unsafe
temperatures for operation, this message will appear in
the DIC and you will hear a chime.
Stop and turn off the vehicle as soon as it is safe to do so
to avoid severe damage. This message will clear when
the engine has cooled to a safe operating temperature.
FUEL LEVEL LOW
If the fuel level is low, this message will appear on the
DIC and you will hear a chime. Refuel as soon as
possible. Pressing any of the four DIC buttons will clear
the message from the DIC display. If your vehicle does
not have the four DIC buttons, pressing the trip odometer
reset stem will clear the message from the DIC display. It
will also clear itself after 10 seconds until the next ignition
cycle. The low fuel light near the fuel gage will still remain
on in either case. See Low Fuel Warning Light on
page 3-45, Fuel Gage on page 3-45, and Fuel on
page 5-5.
KEYFOB X BATTERY LOW
If a remote keyless entry transmitter battery is low, this
message will appear on the DIC. The battery needs to be
replaced in the transmitter. See “Battery Replacement”
under Remote Keyless Entry System Operation on
page 2-5. Pressing any of the four DIC buttons will clear
the message from the DIC display. If your vehicle does
not have the four DIC buttons, pressing the trip odometer
reset stem will clear the message from the DIC display.
3-53