Specifications

Finding a Station
AM FM: Press this button to switch between AM, FMI
and FM2. The display will show your selection.
TUNE: Turn this knob to choose radio stations.
a SEEK D : Press the right or the left arrow to seek
to the next or to the previous station and stay there.
To scan stations, press and hold one of the SEEK
arrows for two seconds until you hear a beep. The radio
will go
to a station, play for a few seconds and flash
the station frequency, then go on
to the next station.
Press one
of the SEEK arrows again to stop scanning.
To scan preset stations, press and hold one of the
SEEK arrows for more than four seconds until you hear
two beeps. The radio will go
to the first preset station
stored on your pushbuttons, play for a few seconds and
flash the station frequency, then go on
to the next
preset station. Press one of the SEEK arrows again
to
stop scanning presets.
The six numbered pushbuttons let
you return to your
favorite stations. You can set
up to 18 stations (six AM,
six FMI and six FM2) by performing the following
steps:
1. Turn the radio on.
2. Press AM FM to select AM, FM1 or FM2.
3. Tune in the desired station
4. Press and hold one of the six numbered
pushbuttons until you hear a beep. Whenever
you
press that numbered pushbutton, the station
you set will return.
5. Repeat the steps for each pushbutton.
The radio will seek and scan only
to stations that are in
the selected band and only
to those with a strong
signal.
3-43