Specifications

Starting up and Operating
- 43 -
downshift the transmission to the
nearest low gear.
4. Under manual mode, the up shift
can be performed at any vehicle speed;
however, the downshift can only be
performed once the vehicle speed
lowered to allowable scope.
5. When to shift the gear selector lever
from P to R, from N to R, or from R to
P, the limit button on the gear selector
lever must be pushed down to release
the gear selector lever lock. It‘s no
necessary to push down the limit
button when shift the gear selector
lever at other positions.
Start
Keep the engine running at idling
speed, step down the brake pedal, and
shift the gear selector lever to
whichever drive gear.
The vehicle will travel itself slowly
after the brake is released. Step down
the accelerator pedal to increase the
vehicle speed.
! Notice: The vehicles with automatic
transmission can‘t be started by trailing
or pulling the vehicles. Please conduct
jumper start by means of connecting
the jumper cable to the support battery.
Under special conditions, it may shift
to manual mode gear 2 as the start gear
on the ice & snow covered roads.
Drive out Sand and Snow
If the drive wheel is entrapped in the
sand or the snow, try to shake the
vehicle by repeated forward/backup.
Shift the gear selector lever between D
and R and step down the accelerator
slightly. In order to enhance the effects,
it can shift to R when the vehicle is
still moving forward and vice versa.
Avoid the long period gearshift
(shaking) between forward and backup,
which may result the excessive
worn-out of the transmission. The
shaking period should not exceed 1
min. Try best to keep the engine at low
speed during the vehicle shaking.