Specifications

In Case of an Emergency
- 146 -
electrical appliance.
- Don‘t touch the battery while
jump starting.
- Do not make two conducting
wires which help to start, short
connect.
- Pull parking brake, place gear bar
to neutral gear.
Jump starting procedure:
Connect one end of the first jumper
cable to the positive (Marked with ―+‖
on outer shell of battery of connecting
wire column which helps to start the
engine)
·Connect the other end of the first
jumper cable to positive ―+‖ marking
on outer shell of battery which is low
but not flat.
· Connect one end of the second
jumper cable to the negative (-) on
booster battery.
· Connect the other end of second
jumper cable to engine block of other
vehicle or bolt connecting wire which
is supported by the engine.
Do not connect the jumper cable to
negative connecting wire column of
flat battery.
The recommended connecting point
shall be far away from the flat battery
as possible as you can.
Make the jumper cable aligned in
order to avoid touching the adjustable
components in engine room.
Vehicle engine which provide jump
starting can be normally working
during period of jump starting.
Start the vehicle whose battery is flat
within on e minute as possible as you
can, lasting time shall be within 12
seconds. You shall disconnect the
connection without delay after starting.
！Notice;
Turn off all lights and accessories
while jump starting the engine, in
order to avoid other systems or
components being damaged, do not
start your vehicle by means of pushing
and pulling, to do so, maybe damage
ternary catalytic converter and other
electrical components.