Specifications

In Case of an Emergency
- 143 -
ignition key.
- Turn on your emergency flashers,
firmly set the parking brake, if
necessary, put into gear 1 or reverse
gear.
- Put a cuneiform spacer or something
can be used as obstacle to hold the
wheel, on the rear or front direction
of the wheel diagonally opposite the
flat tire.
- Set a warning triangular signpost, 10
M away from the vehicle.
- Have everyone get out of the vehicle
on the side away from traffic, to a
safe place.
Procedures of replacement
- Pry off rim cap.
- Loosen every wheel bolt for one
circle with wheel spanner, but do
not remove the bolts yet, just
unscrew them about one-half turn,
before raising the wheels.
- Position the jack at the correct
jack point as shown. Put jack
vertically close to front or back
direction of the flat tire. Rotate
jackscrew clockwise by hand,
until jack top touches the vehicle
bottom.
Insert the jack handle into the jack and
turn it clockwise, so as to raise vehicle,
until top of jack embedded in concave
groove firmly and the wheels depart
from the ground (about 3 CM).
Loosen
Tighten