Manual

Engine Maintenance And Servicing Manual
——Loosen and remove two M6× 20 bolts.
——Remove the distributor.
——Remove the distributor’s “O “seal.
Assembly:
——Insure that the engine is set correctly with No.1 Cylinder
at TDC.
——Install new “O” seal.
——Rotate distributor to align the lug with the No. 1 cylinder
TDC mark on the distributor flange. Install the distributor
inserting the lug into the camshaft groove.
——Rotate distributor to align the mark on distributor flange
with the mark on cylinder head.
——Tighten two bolts to 5.0—7.0Nm.
6. High tension ignition wire assembly:
The high tension ignition wire assembly is mounted on the
cylinder wire bracket which is installed on the valve cover, also
cylinder wire and coil wire clips exist between the distributor
Fig. 129 distributor assembly
Groove
Camshaft
Tongue
TDC mark
Fig. 130
Slave cylinder and high pressure wiring harness
Slave cylinder and high
pressure wiring harness
High pressure
cable assembly
Flat washer
Slave cylinder and high pressure
wiring harness carrier
Fig. 131
Bolt
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.com.cn