User manual

Instruments and control devices
63
Passing light switch
Headlight high beam will come on if
control lever is turned towards steering
wheel, then control lever may be released.
Control lever will return to normal
position after released. Headlight high
beam will remain on when control lever
is hold on by driver.
Windshield wiper switch
With ignition switch turned on,
windshield wiper may be operated when
control lever is turned upward.
OFF=stop.
INT=intermittent wiping (with a interval
of 4 seconds)
LOW= continuous wiping, low speed
HIGH= continuous wiping, high speed
Fuzzy function
If driver turn control lever to INT
position lightly and release it, wiper will
operate once. Wiper will work once after
control lever return to normal position
automatically.
！Notice
If wiper blades are worn, which will
cause a improper wiping affecting front
sight, wiper blades should be replaced.
With no water, wiper's operation will
scrape glass resulting in premature
deterioration of wiper blades and
disturbing driver’s visual field. Wiper is
not suggested to apply when water is not
available.
Windshield washer
switch
With ignition switch on, liquid in washer
will be injected to windshield if control
lever is turned towards steering wheel. If
control lever is turned less than 0.5
second, liquid in washer will be injected
to windshield at first, then windshield
wiper will operate several cycles. Wiper
will stop automatically after control lever
is released.