User manual

Instruments and control devices
62
It shows that the mileages remained from
the service mileage set are 100 km, 50
km and 0 km respectively. Each reminder
is accompanied by the beep sound, with
the duration of 10 s.
● Status or initial value of the
instruments re-powered after power off
Both the positive input of power supply
and the positive input of ignition switch
POWER OFF, and the relevant data of
the instruments will be lost after
re-powered on. The related initial values
of common instruments can be restored
as follows:
⒈ Clock display: 00:00
⒉ Traveling time: 00-00
⒊ Service mileage: 0, it is required to
reset.
⒋ Brightness value: Daytime----100;
Nighttime----1.
⒌ Brightness control mode: The default
mode is knob-operated control.
Turn signal light switch
Turn signal lights may work only when
ignition switch is turned on. A right turn
will be signaled when turn signal light
switch is moved up. A left turn will be
signaled when turn signal light switch is
moved down. Turn signal lights will go
out after turn and turn switch returns to
normal position.
When driveway shift is made ,move
switch not completely (without finishing
full travel) and hold on it. Turn signal
light switch will return to its normal
position after released.
Headlight high beam
switch
With headlight low beam on, headlight
high beam will be turned on when control
lever is pushed towards dashboard and
high beam indicator light will light up
simultaneously.
Headlight low beam will be lit up when
control lever is pushed back to original
position.
！Notice
Here, headlight switch must stay
"
" position all the time.