User manual

Notices Before Drive
10
Operations in the phase of
test-drive
Some simple protective measures should be
followed during the initial running-in period
which can improve
drivability and
economy of the vehicle
and prolong its
service life.
 Do not run engine in high speed at
idle;
 Do not overload engine
possibly
while us ing
transmission drive;
 Avoid using emergency brake
unless there is an emergency;
 Avoid stepping down accelerator at
neutral during start;
 The engine requires a period of
time for warming-up after start
 Avoid drawing other cars;
 Avoid any rigor operations such as
emergent start, sudden acceleration
and long-time high speed running
which will not only do harm to the
engine, but also increase fuel and
oil consumption and even damage
engine components. And especially
try to avoid stepping down
accelerator pedal to the end under
bottom gear.
Before entering the car
 Inspect if windows, outside
rearview mirror and lamps is clean
or damaged;
 Inspect if tire pressure is normal;
 Inspect
if all vehicle lights are
normal;
 Watch if there is any obstacles
behind the car;
 Inspect
if fuel pipes leak
 Inspect
if engine oil level and
other fluid level are within
standard range.
Before driving
 Make sure that you have known the
condition and equipments of t he
vehicle, and how to operate them
safely.
 Adjust the position of the seat;
 Adjust the angle of interior and
outside mirrors on the car.
 Insure that all passengers have tied
up their seat belt.
 When turning the ignition switch to
position II, you should inspect
whether the alarm lights have
gone
out after automatic detection.
！Notice
Please inspect if windows,
rear windshield, all
lamps, signal
transmission system and
warning indicator are
normal. Do not put
anything on rear luggage