User manual

Emergency situation
96
-Insert jack crank handle into jack and
turn jack handle clockwise to raise
vehicle until the rising head of jack is
seated in recess tightly and wheel is off
the ground(about 3cm).Do not raise
vehicle too high and recheck jack
position against slipping when jack
contacts vehicle and vehicle begins to
rise .
-Turn wheel attaching bolt anticlockwise
to remove bolts , then remove wheel..
-Install spare wheel in place and tighten
wheel bolts clockwise by hand.
-Rotate jack anticlockwise to lower
vehicle to the ground. Tighten wheel
bolts according to requirement on "
diagonal " order(1 - 2 - 3 - 4).
-Install wheel cover If improper wheel
bolts are used or bolts are not tightened
properly, wheel may get loose or break
off causing vehicle out of control.
-Apply proper wheel bolts
-Ensure that wheel bolts are positioned
rightly and tightened firmly.
-Do not apply engine oil or lubricant on
wheel bolts.
！Notice
Vehicle may be in instable state when
using jack, even causing
accident.,Therefore:1 、 Position jack in
right jacking points.2 、 Position jack
perpendicular to the ground during
installation.3、Do not get under jacked
vehicle and do not start vehicle on jack.4,
Before jacking, have all passengers out of
vehicle to safe area.5、Jack is designed
only for wheel replacement.6、Do not
jack vehicle on slope or smooth
surface.7、Position jack at the side nearer
to the wheel to be replaced and hold the
wheel diagonal to the wheel to be
replaced.8、Before jacking, ensure that
hand braking is applied and transmission
is in" 1"gear or "R" gear if necessary.9、
Do not replace tire where is near the
place with heavy traffic.Special Notice:If
you are not sure about tire replacement,
contact the nearest CHERY AUTO
authorized service station for help.