User Manual
Table Of Contents
- Contents
- 1 Introduction to the Dolby Accessibility Solution User’s Manual
- 2 Dolby Accessibility Solution hardware components
- 3 Installing the Dolby Accessibility Solution Server
- 4 Configuring the Dolby Accessibility Solution audio
- 5 Configuring the Dolby Accessibility Solution with a Wi-Fi router
- 6 Configuring the Dolby Accessibility Solution Server with a digital cinema server
- 7 Configuring the Dolby Accessibility Solution Receiver
- 8 Setting up a Dolby Accessibility Solution Receiver for a patron
- 8.1 Enabling the talkback feature for visually impaired patrons
- 8.2 Connecting the Dolby Accessibility Solution Receiver to an auditorium
- 8.3 Selecting available resources for Brazil
- 8.4 Selecting available resources for regions other than Brazil
- 8.5 Adjusting the Dolby Accessibility Solution Receiver adjustable arm
- 9 Dolby Accessibility Solution default user accounts and passwords
- 10 Updating the Dolby Accessibility Solution system
- 10.1 Updating the Dolby Accessibility Solution Server software using secure FTP
- 10.2 Updating the Dolby Accessibility Solution Server software using USB
- 10.3 Updating the Dolby Accessibility Solution Server software using the web UI
- 10.4 Updating the Dolby Accessibility Solution Receiver software using the web UI
- 11 Dolby Accessibility Solution Server web UI
- 12 Dolby Accessibility Solution operational and technical specifications
- 13 Audio AES and adapter pinouts
- 13.1 RJ-45 Ethernet cable color codes
- 13.2 RJ-45 to 25-pin D-connector male adapter pinning
- 13.3 Pinouts for AES3 channels 1-8 output
- 13.4 Pinouts for AES3 channels 9-16 output
- 13.5 Pinout wiring for AES3 audio for Dolby cinema audio processors
- 13.6 Pinout wiring for AES3 audio for third-party cinema audio processors
- 13.7 Pinouts for the Dolby CP750 in 5.1 mode
- 13.8 Pinouts for the Dolby CP750 in 7.1 mode
- 13.9 Dolby CP850/Dolby CP950 pinouts
- 13.10 25-pin D-connector to dual RJ-45 adapter pinout
- 13.11 Pinouts for the Dolby IMS3000 AES3 auxiliary input or output port
- 13.12 Dolby DCP‑2000/Dolby DCP‑2K4 AES pinouts
- 14 Documentation revision history
- Glossary
Note: All Dolby Accessibility Solution Receivers are updated using a connection to the Dolby
Accessibility Solution Server. We recommend identifying a Dolby Accessibility Solution Server that
will be used to update the Dolby Accessibility Solution Receivers. The IP address entered here is
the IP address of that Dolby Accessibility Solution Server ETH-1 port.
9. Ensure that the RSSI Limit is set to 70, as shown in the following figure.
10. To save any changes, tap BACK.
Figure 34: Revised SSID Settings
Results
This completes the Dolby Accessibility Solution Receiver initial setup and configuration.
Configuring the Dolby Accessibility Solution Receiver
Dolby Accessibility Solution Userʼs Manual 44
AST.OM.005498.DRM Issue 4 14 June 2022
DRAFT