User's Manual

A. The human body is outside the radar range

Radar scanning range, and adjust the installation

angle.Radar measurement range, in different environments,

the electromagnetic wave reflected area is different, the

scanning area will have small differences.

B. Metal occlusion causes an incorrect output

Overthick office tables and chairs, metal seats.It will

block the electromagnetic wave penetration, causing

misjudgment.

C. Scan angle difference

The radar was not scanned to the trunk position.Cause a

miscarriage of judgment.

D. Radar sensitivity is too low

Radar provides parameter adjustment to increase sensitivity

improvement.

6. Functional details

6.1. Function point description

Function point

Status change time / function explanation

DP1：Someone / nobody

No one arrived, reported within 0.5s

Someone to no one, 1-2 minutes or so

output no state， 0.5s

DP2：Someone is still / someone is active

Static dynamic switch, reported within 0.5

seconds

DP3：Someone is close to the equipment /

Someone moves away from the

device / someone moving without

direction

Output the status once in 2 seconds

DP4：Body motion amplitude parameter 0

– 100

Output the data once in 5 seconds Refer

to (Description of the bulk motion

amplitude parameter output)

DP5：Sensitivity is set in gear 0- 9

In default scenario mode, 10 gear

adjustments are supported