User Manual

Aircraft and Accessories Update

1. Autopilot

The customer will receive the update file from JOUAV if it is need to be updated. We suggest

updating the autopilot immediately if customer receive the update.

2. CWCommander

If there is new version of CWCommander, the software will remind you when you start it. And if

you choose update, it will download and install automatically.

3. GCS-202

We will send the update to customer if it’s needed to be updated. And we suggest updating

immediately.

4. Others

e POS processing software, update software and so on. We will send to customer if there is

new version.

For CW-007/GCS-202 (Unmanned Aerial Photography UAV)

FCC Statement:

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s

authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment

should be installed and operated with minimum distance 20cm between the radiator& your body.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular in

stallation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.