User Manual

After Landing

After landing, disconnect the rotors power and

engine power, switch off the RC. And

then download the POS data if it’s needed.

1.Download POS data from Airborne



 Step 2: open the Recorder software, select the serial number and set the baud rate by default.

 Step 3: power on the UAV, and after 5 seconds, switch Norm to Boot.

Must download POS data before power off the autopilot, or the next flight will cover the last

POS data. If the autopilot is off, you can input photo number manually. And we suggest downloading

the rover data and base data after every flight.

Step 1: when the UAV is power off, use the data download cable to connect the computer and the

UAV. The data download cable is adjusted to Norm-422

Data Download