User Manual

CW-007 II Operation Procedure

We suggest that the aircrew consists of 1 or 2 people, and the aircrew operate this UAV system as

blow procedures. One of them who in charge of the ground control station, the rest people who check

the aircraft and prepare for the emergency situation. And only one person can also finish all the

operation.

Preparing

Battery:

Make sure all the batteries are full charged, including aircraft, radiocontroller, GCS-202,

laptop, external battery for GCS-202.

CWCommander:

Load the map of mission area. Create the flight plan and check the elevation

before flight to save time when you’re outside.

Aircraft:

Confirm no damageduring storage or transportation, and allcomponents are correctly

positioned in the backpack case.

Do not put desiccant and other little things into the flight case when transport the case

GCS-202 Installation

Confirm the WiFi antenna and the data link antenna are fixed, and then install the GCS-202 to the

tripod. If it’s needed, connect the external battery to increase work time. And then, power on the

GCS-202.

Measure the slant height or connect the fiber glass antenna if it’s needed.

The GCS-202 should be far from ground, vehicles, buildings.