User Manual

18Copyright©JOUAV
too low (less than 10℃), the performance of the battery will be reduced and cannot meet the
requirements of normal use. Please start the heating function in advance, and it can be used
normally when the temperature is restored.
 Battery charging environment temperature should be between 5℃ and 45℃, low
temperature (below 5℃) charging will cause irreversible damage to the battery, even personal
injury.
 Please use the original charger for charge and discharge, do not charge and discharge when
unattended.
 If the battery falls from the UAV or is hit by external force, it shall not be used again.
 When removing batteries from the UAV, be sure to protect them from hitting the ground. Do
not pull the handle strap violently.
 If there is dirt in the battery socket, clean it with a dry cloth. Otherwise, poor contact can
result in energy loss or failure to charge.
 The liquid inside the battery is corrosive. If there is leakage, please stay away from it. If
internal fluid spatters on human skin or eyes, rinse immediately with water and go to a doctor
immediately.
 When the battery is not used properly, such as short circuit, overcharge, over discharge, etc. ,
it may cause fire or explosion.
 When placing the battery, make sure the ground is flat to prevent sharp objects from poking
the bottom of the battery.
 The battery is heavy. Please place it carefully to prevent the battery from toppling and
causing side damage. In case of battery damage, please immediately place the battery in an open
area where is away from combustible materials and people. After half an hour, soak the battery in
water for more than 24 hours. Ensure that the battery is completely exhausted before disposal.
 If the battery accidentally falls into the water during the flight of the UAV or under other
circumstances, please pull out the battery immediately and place it in a safe and open area, and
stay away from the battery until it is completely dried. Dry batteries are not allowed to be used
again and should be disposed of properly in accordance with the waste method described in this