User Manual

2. Camera Control Box and Settings

When changing camera Settings and formatting memory CARDS, you need to use the camera

control box to view and operate. The operation panel of the camera control box is shown below

Usage of camera control box is:

1) Make sure the camera power is

switched off

2) Connect the HDMI cable and control

cable

3) Turn on the camera power

4) Use the control box panel to set

parameters

5) Turn off the camera's power, and wait 30 seconds to re-start. Make sure the Settings are saved.

6) Turn off the power again and disconnect the cable

Do not energize on or off the camera when the power switch is on!

3. Maintenance



Storage: the CA-100 camera is recommended to be powered once a week. If it is not

powered for a long time, please keep it dry and dust-proof.



Transportation: please use packing box to transport and avoid inversion.

4. Other Payload

For non - standard UAV, function and use of different payloads, please refer to the manual