User's Manual
4/4
6.Operation state and power consumption
State Operation Current (mA)
State 1: wake-u
p
6
State 2: pre-processing 7.4
State 3: pre-receiving 11
State 4: receiving 17.5
State 5: Rx changed to TX 7.4
State 6: transmitting 17.5
State 7:
p
re-
p
rocessin
g
7.4
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interfere
nce in a residential installation. This equipment generates and can radiate radio frequency energy and, if no
t installed and used in accordance with the instructions, may cause harmful interference to radio communic
ations. However, there is no guarantee that interference will not occur in a particular installation. If this equi
pment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the fol
lowing measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1)Thi
s device may not cause harmful interference, and (2)This device must accept any interference received, in
cluding interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modific
ations to this equipment. such modifications could void the user’s authority to operate this equipment.
FCCRFRadiationExposureStatement
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.