User's Manual

When Beacon stays asleep, this mode will wait for being wake-up.
Connectable Mode
Beacon can only be connected in this mode, which needs triggered by tapping
Beacon, and it will last for 45 seconds. It means that Beacon can be connected in
45 seconds after being triggered. And Beacon will restore to sleep mode or
non-connectable mode if it is not connected in 45 seconds.
Non-Connectable Mode
Beacon can radio Beacon’s data properly in the non-connectable mode. Beacon
will begin to work normally when configured to this mode and it cannot be
connected. If you want connect it again, you must tap it five times, and it can be
connected within 45 seconds. Once timeout, it will restore to non-connectable
mode. If connection is needed, Beacon must be tapped again.
Key Words
Power Value: This value represents the power value mobile scanned when the
distance between Beacon and phone is within a meter.
TX Power: This value represents the Beacon’s firmware Transmit Power
RSSI: The value is the signal strength of the scanned device which can be used to
measure the distance
Electronic Parameters
Item Test Data Remarks
Chip model nRF51822 Nordic Semiconductor 256k