User's Manual

SZU06A2 Product Manual
SZU06A2 PM(Rev 2.0)
4

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

Consult the dealer or an experienced radio/TV technician for help.

Please take attention that changes or modification not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
FCC RF EXPOSURE STATEMENT:
The device has been evaluated to meet general RF exposure requirement, The device
can be used in portable exposure condition without restriction.
2.3
ATEX Approvals
The SZU06A2 ZigBee wireless communication module has been tested to comply with the
ATEX 2014/34/EU regulation about explosion proof products. Intended Use:Zone 2 GAS.
This device meets the following parameters:
i i i i i s
U =3.9V, I =1A, P=0.98W, C =15.32 μF, L =5.64μH, -40 T 80 . ℃ ℃
And it complies with the following standard:
 EN 60079-0:2012+A11:2013
 EN 60079-11:2012
Ex marking:
Certificate number:
When installing the SZU06C1 module into your own product and requiring explosion protection,
please make sure that your product must meet the above explosion-proof parameters and
indicate "Transceiver Module II 3G Ex ic IIC Gc" or similar words outside the final product.