User's Manual

SZU06A2 Product Manual
SZU06A2 PM(Rev 2.0)
1
1
General
1.1 Module introduction
SZU06A2 introduced in this document is an embedded wireless communication module based
on IEEE802.15.4/ZigBee technology. The hardware has taken the EFR32MG1V132 chip
solution of Silicon Labs and the software adopts the SZU06 AT instruction set self developed
based on Ember Z-net_5.9.0 protocol stack released by Silicon Labs.
The advanced hardware design and the simple AT instruction interface enables SZU06A2
ZigBee wireless communication module to be blended into the wide range of applications.
Due to the strong configuration function of SZU06A2 AT instruction set, you can develop the
products without extra MCU to save more time and cost. Besides, SZU06A2 ZigBee wireless
communication module is also an ideal platform for development of ZigBee firmware apart
from the use of customized firmware.
You can add the strong network function into your products without radio frequency experience
or expertise, which can greatly shorten the research and development period of products and
further speed up the marketing of the products.
1.2 Hardware description
SZU06A2 ZigBee wireless communication module is composed of the high performance and
low power consumption RF chip EFR32MG1V132 from Silicon Labs, 38.4MHz system clock
crystal oscillator, 32.768KHz monitoring clock oscillator and RF radio frequency front-end
matching circuit which can optimize the radio frequency performance.
The module has been integrated a snake antenna on board, so that you can integrate it into
your own products easily.
The maximum output power of RF chip is 8dBm, and the receive sensitivity is -100dBm
typically.