User's Manual
Table Of Contents
- General
- Module introduction
- Hardware description
- Approvals
- CE Approvals (ETSI)
- FCC Approvals
- ATEX Approvals
- Module Pinout
- Hardware Description
- Hardware Diagram
- Interface characteristics
- Absolute Maximum Ratings
- Environmental characteristics
- Recommended operating conditions
- DC Electrical Characteristics
- Digital IO Specifications
- AC Electrical Characteristics
- Physical Dimensions and Footprint
- Physical Dimensions
- Recommended Footprint
- Soldering Temperature Time Profile (for reflow so
- Recommended temperature time profile for lead-fre
- Reliability Test
- Application Precautions
- Safety precautions
- Engineering design and using precautions
- Storage conditions
- Packaging
- Carrier tape
- Reel
- Ordering Information
- Drawing of Product Label
- Disclaimer
- RoHS Declaration
- Data Sheet Status
- Reference Documents
- Contact Information
SZU06C2 Product Manual
SZU06C2 PM(Rev 2.0)
6
partial certification may be used as a basis for certification of equipment or protective
system.
2. The maximum input parameters stated above shall be considered during installation.
The rules for interconnection of intrinsically safety circuits according EN 60079-11 and
EN 60079-14 have to be taken into account.
3. The maximum service temperature of the communication module when incorporated
into apparatus is -40°C to +80°C. When utilized at this service temperature, a T4
temperature classification is suitable.
4. The communication module shall be installed in an enclosure that provides a minimum
ingress protection of IP20.