Datasheet
1-770-424-4888 www.chemtronics.com
Rev. F (4/30) Page 2 of 2
8125 Cobb Center Drive, Kennesaw, GA 30152 1-770-424-4888 www.chemtronics.com
IPA
Presaturated Wipes
Product# SIP100P
Compatibility
IPA Presaturated Wipes are generally compatible with most
materials. As with any chemical product, component
compatibility must be determined on a non-critical area prior
to use.
Usage Instructions
For industrial use only. Read SDS carefully prior to use.
SIP100P tub directions:
Remove top of container and peel foil seal from top of tub. Pull
the first wipe from center of roll and feed it through the opening
in the lid. Replace lid, pull first wipe from the tub, and separate
at perforation. Keep container closed during and after each
use to prevent wipes from drying out.
IPA100B box directions:
Open box and remove wipes from pouch found inside box.
Pull wipes as needed from the box and close box between
uses to prevent wipes from drying out.
Cleaning directions:
General cleaning: Wipe surfaces thoroughly to remove
contaminants. When removing heavy soils, use a clean wipe
for final wipe down.
Stencil cleaning: Wipe away residual solder paste until
surface is thoroughly cleaned. Repeat with a clean wipe to
remove any trace contaminants.
Availability
SIP100P Presaturated wipes (100/tub)
IPA100B C-Fold wipes (100/box)
Environmental Impact Data
HCFC-141b None
HCFC-225 None
HFC None
nPB None
Hydrochlorofluorocarbons (HCFCs) are regulated under the
Montreal Protocol as Class II ozone depleting substances.
HCFC-141b is no longer produced in the US under this
legislation. HCFC-225 is planned for production phase-out in
2015. Hydrofluorocarbons (HFCs) are not currently regulated.
EPA has listed n-propyl bromide (nPB) as an acceptable
alternative to ozone depleting substances in metal, precision,
and electronics cleaning under Section 612 of the Clean Air Act.
Technical and Application Assistance
Chemtronics provides a technical hotline to answer your
technical and application related questions.
The toll free number is: 1-800-TECH-401.
Note:
This information is believed to be accurate. It is intended for
professional end users having the skills to evaluate and use the
data properly. CHEMTRONICS does not guarantee the
accuracy of the data and assumes no liability in connection with
damages incurred while using it.