Datasheet

Rev. K (5/19) Page 1 of 2
1-770-424-4888  www.chemtronics.com
Typical Product Data and Physical Properties
COMPOSITION:
Material: Silver Filled Polymer
Silver Concentration: 55% +/-2%
Silver Particle Size: <20 microns
Color: Silver Gray
Settle Rate: < 2mm/hr.
PROPERTIES:
Conductivity: 0.02-0.05 ohms/sq/mil
0.00005-0.000125 ohm cm
Max. Temperature: 400°F (205°C)
Tack-Free Time: 3 to 5 minutes
@25ºC
Full Cure Time: 20 to 30 minutes
@25ºC
Solder Wetting: 2 to 3 seconds
Electrical Conductivity: Excelllent
Adhesion: Excellent
Flexibility: Good
Chemical Resistance: Good
Tip Diameters:
MTP: 0.8 mm (0.03 inches)
STP: 1.2 mm (0.05 inches)
Shelflife 15 months
Yes RoHS Compliant
CircuitWorks

Conductive
Pens & Paint
Product# CW2200STP, CW2200MTP, CW2205
Product Description
CircuitWorks® Conductive Pens and Paint make instant highly
conductive silver traces on circuit boards and are used in
prototype, rework, and repair of circuit boards by linking
components, repairing defective traces, making smooth
jumpers and patching EMI shielding. The silver traces dry in
minutes and have excellent adhesion to most electronic
materials. Engineers, repair technicians, and manufacturers will
find that the CircuitWorks Conductive Pens and Paint speed
project completion and cuts rework time.
 Single component system
 High electrical conductivity
 Fast drying
 Highly adherent to circuit boards
 Operating temperature to 400
°F (205°C)
Typical Applications
CircuitWorks Conductive Pens & Paint may be used for
electronics applications including:
 Circuit trace repair
 Solderless linking of components
 EMI shielding
 Solderable terminations
 Quick prototype modifications
Compatibility
CircuitWorks conductive material has excellent compatibility with
materials used in printed circuit board fabrication. As with any
chemical system, compatibility with the substrate must be
determined on a non-critical area prior to use.