Datasheet

Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II - Europe
NA - Chem-Wik® Rosin/Chem-Wik® Rosin SD
SECTION 7: Handling and storage
:
Industrial sector specific
solutions
Not available.
Recommended monitoring
procedures
No exposure limit value known.
Occupational exposure limits
If this product contains ingredients with exposure limits, personal, workplace
atmosphere or biological monitoring may be required to determine the effectiveness
of the ventilation or other control measures and/or the necessity to use respiratory
protective equipment. Reference should be made to monitoring standards, such as
the following: European Standard EN 689 (Workplace atmospheres - Guidance for
the assessment of exposure by inhalation to chemical agents for comparison with
limit values and measurement strategy) European Standard EN 14042 (Workplace
atmospheres - Guide for the application and use of procedures for the assessment
of exposure to chemical and biological agents) European Standard EN 482
(Workplace atmospheres - General requirements for the performance of procedures
for the measurement of chemical agents) Reference to national guidance
documents for methods for the determination of hazardous substances will also be
required.
Hand protection
Use a properly fitted, particulate filter respirator complying with an approved
standard if a risk assessment indicates this is necessary. Respirator selection
must be based on known or anticipated exposure levels, the hazards of the product
and the safe working limits of the selected respirator.
Use chemical-resistant, impervious gloves.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists
or dusts. If contact is possible, the following protection should be worn, unless the
assessment indicates a higher degree of protection: safety glasses with side-
shields.
Eye/face protection
Respiratory protection
:
:
:
:
Skin protection
Personal protective equipment for the body should be selected based on the task
being performed and the risks involved and should be approved by a specialist
before handling this product.
:
Appropriate engineering
controls
:
If user operations generate dust, fumes, gas, vapour or mist, use process
enclosures, local exhaust ventilation or other engineering controls to keep worker
exposure to airborne contaminants below any recommended or statutory limits.
Wash hands, forearms and face thoroughly after handling chemical products,
before eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and
safety showers are close to the workstation location.
8.2 Exposure controls
Hygiene measures
:
No DNELs/DMELs available.
PNECs
No PNECs available
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
DNELs/DMELs
Individual protection measures
Body protection
:
Other skin protection
Appropriate footwear and any additional skin protection measures should be
selected based on the task being performed and the risks involved and should be
approved by a specialist before handling this product.
The information in this section contains generic advice and guidance. Information is provided based on typical
anticipated uses of the product. Additional measures might be required for bulk handling or other uses that could
significantly increase worker or exposure or environmental releases.
Date of issue/Date of revision
:
6/27/2013.
Date of previous issue
:
6/24/2013.
Version
:
1.01
6/12