Use and Care Manual

7
Milkmade Non-Dairy Milk Maker
CLEANING THE MILKMADE NON-DAIRY MILK MAKER:
The machine will automatically enter “Self-cleaning” mode after the milk
making process. The cleaning cycle is a total of seven minutes, as such
the control panel will flash 00:07. Check the water tank at the back of the
machine. Water should reach the cleaning mark on the water tank. If there is
insufficient water in the tank, the machine will beep. Open the lid and pour
more water into the tank until it reaches the cleaning mark. Once the lid is
closed the cleaning cycle will begin. The Milkmade will beep again when it
has finished self-cleaning.
After the machine has completed the cleaning cycle, make sure to empty
and clean out the wastewater basin with water. The glass pitcher, water
reservoir, grinding compartment cover, and steam cover can all be removed,
cleaned with water and air-dried. The grinding compartment should also be
cleaned and air-dried with the cover open.
Sizes include:
• 10 fl. oz.
• 20 fl. oz.
Standby Mode: If the machine is not in use for a few minutes, it will go into
standby mode. Simply press the “Start/Stop” button to turn the control
panel back on.
Additional Cleaning Programs
If the self-cleaning cycle doesn’t sufficiently clean the machine, you may
perform an additional cleaning cycle. Choose one of the three cleaning
programs below, depending on the level of cleaning intensity you prefer.
1. Quick Clean - Press the “Auto Clean” button once for a quick clean.
0:03 will be displayed on the control panel, and the “Clean” indicator
lights up.
2. Deep Clean - Press the “Auto Clean” button twice for a deep clean.
0:08 will be displayed on the control panel, and the “Clean” indicator
lights up.
3. Dry Clean - Press the “Auto Clean” button three times to choose the
cleaning program that will clean without water. 0:10 will be displayed on
the control panel. Please note: the “Clean” indicator will not light up.