IMPORTANT NOTICES When using an electrical appliance, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury, including the following: 1. Read all instructions before using. 2. Remove all packing material and carefully check your ice maker to ensure it is in good condition and that there is no damage to the ice maker or power cord and plug. 3.
IMPORTANT NOTICES [= This symbol indicates the refrigerant R600a and the non-metallic materials of the appliance are flammable. t's a warning symbol. WARNING: Risk of fire/flammable materials. WARNING: When positioning the appliance, ensure the supply cord is not trapped or damaged. WARNING: Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.
CONTROL PANEL OPERATION indicator light ADD WATER gre SMALL ICE ele gil fT ES LARGE ICE edge lee ae ICE MAKING pel ici LIE ay Lec tL ld] CONTROL PANEL OPERATION 1. POWER: plug in the power, the "POWER" indicator light flashes, and the machine is in standby mode. Press the POWER button, the "POWER" indicator light always being on and then enter the operating state.
CONTROL PANEL OPERATION 4. ADD WATER: water shortage alarm When the "ADD WATER" light flashes, it means that there is water shortage in the water tank. You need to add water and press the POWER button to restart the machine. 5. ICE FULL: ice full alarm When the ice reaches the maximum capacity of the Ice storage container, the "ICE FULL" light flashes, and the machine stops. At this time, the ice needs to be poured out.
1. The three cycles used for the first time, the ice produced is small and irregular. 2. When the ice basket is full, please take out the ice immediately, do not let the ice overflow the lee collecting tray. CLEANING & USING GUIDANCE Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the Inside and the outside surface of the ice maker.
TROUBLESHOOTING 1. Please notch, if a power failure occurs due to disconnection of the power cord, or the power button has been pushed off during an ice making cycle, small ice chips may be formed and lodge In the automatic shovel causing It to Jam. If this occurs, the ice chips may be removed by disconnecting the power cord and gently pushing the shovel to the rear of the cabinet and removing the ice chips, then restarting. 2.
pe 1. If the power cord is damaged; it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard. 2. Fill with potable water only. 3. It Is normal for the compressor and condenser surface to reach temperatures between 70°C and 90°C during operation and surrounding areas may be very hot. 4, Due to fast freezing, ice cubes may turn opaque. This is air trapped in the water and will not affect quality or taste of Ice. 5.
