User manual

installation (continued)

door conversion for models with

side opening doors

Side opening door models can be converted from left

handopening(asdelivered)torighthandopening.Itis

recommended that the installer complete the door conversion,

at the time of installation� To do this, use the following

instructions:

• Openthedoorfullysoaccesstothetophingebracket

can be had with a Philips head screwdriver�

• Whilstensuringthattheweightofthedoorissupported,

unscrew the two screws at “A” on the top hinge bracket�

• Tiltthedoorslightlyawayfromtheapplianceandthe

door can now be lifted off the bottom hinge bracket�

• Placethedoordownonasafeandstablesurfaceand

ensure that the top bracket is also placed in a safe place�

• Thedoorhastwopivotpinsandwashersbeneatheach

hinge bracket� Ensure these are not lost, as they will be

needed to reassemble the door�

• Removethetwoscrewsat“C”onbottomhingebracket.

• Removetheplasticplugonthefrontframeat“B”andalso

remove the insert from the opposite side� Then reverse

these and insert them in the holes of the front frame�

NOTE: to remove the two plugs a small ﬂat bladed

screwdriver will be needed.

• Thetophingebracketcannowbescrewedtothebottom

hinge position on the opposite side� Using the two screws

previously removed, insert and securely tighten�

• Theovendoorissymmetricalandisnowrotated180

degrees so the handle is on the opposite side� The door is

now ready to be reﬁtted�

• Ensurethatthepivotpinsandwashersareinplaceand

also place the bracket previously removed from “C” on

the top hinge bracket of the oven door�

• Positionthedoorbottompivotpinintothebottomhinge

bracket and tilt the door back towards the appliance so

the top bracket is aligned with the mounting holes�

• Whilstsupportingtheweightoftheovendoorinsertthe

two remaining screws and tighten�

• Checkcarefullythattheovendoorcanbeclosedand

opened and is operating correctly�

• Lastly,insertthesquareplastictrims(inthesamebagas

this book) into the hinge brackets at “D”�

Printcode:EXPOVENUM_Sep08

Part number: 0342-001-540

ECN number: 09A119A