User manual

34
33
installation (continued)
door removal
Removing the door from your appliance
• Opendoorfully.
• Rotatethetwostirrupsforwardssothattheyareengaged
together onto the hooks on the hinge arms�
• Holdbothstirrupsinplaceandlightlyclosethedoor.
The stirrups will now remain engaged�
• Closethedoorhalfwayandliftitawayfromtheoven.
• Donotliftthedoorbythehandle,useonehandeithersideof
the door, keeping fingers clear of the hinge arms�
Replacing the door to your appliance
• Relocatebothhingearmsatthesametimeintothefronthousing.
• Ensurethatthelocationnotchesonthebottomofthehinge
arms are positioned onto the lower cutout lip�
• Closethedoorpartiallytoensurethatthelocationnotchdropsintoplace.
• Whenthehingesarelocated,openthedoorfullyandensurethestirrupsaredisengaged.
NOTE: Never use force and always ensure that the location notch is correctly engaged before you operate the door.
important
• Neverliftorcarrythedoorbythehandle.
• Donotimmersethedoorinwater.
cooktop cut-out dimensions (combo models)
Cooktop dimensions
overall cooktop dimensions
width
610mm
depth
515mm
depth of base
45mm
Cooktop cut-out dimensions
A B
cooktop
560mm 490mm
A minimum gap of 40mm must be maintained between the
top of the underbench oven and the bottom of the cooktop to
ensure adequate ventilation and space for the interconnection
lead�
important
THECOOKTOPMUSTBEINSTALLEDDIRECTLYABOVETHE
UNDERBENCHOVEN
A
B
32
installation (continued)
double ovens
side opening door ovens
hard wiring detail
1� Remove terminal cover plate from rear panel of appliance�
2� Fit wires through hole in cover plate and make connections to terminals�
3� Engage wires into plastic clip� Secure plastic clip with two long silver screws
(supplied in separate bag)�
4� Replace cover plate onto rear panel�
NOTE:Doubleoven(ModelPDP794).Thisproductissuppliedwithtwooptional
termination points. Only one termination point is required to be connected.