User Manual

installation
Hard wiring detail
1. Remove terminal cover plate from rear panel of appliance.
2. Fit wires through hole in cover plate and make connections
to terminals.
3. Engage wires into plastic clip. Secure plastic clip with two
long silver screws (supplied in separate bag).
4. Replace cover plate onto rear panel.
Plastic clip
securing points.
Plastic clips
Second active wire only
required (optional) for
multi-phase products.
Separate grill wall oven & pizza oven
WARNING
caution
Note: Dimension “D”.
A requirement for all separate grill wall ovens and all Duo ovens – for proper ventilation there must be a gap at the bottom
rear of the cabinet. This must be a full width opening 20mm deep.
A B C D
Flush fit (mm) 600 893 581(min)
20
Proud fit (mm) 565 885 560 (min) 20
D
B
A
C
561
596
650
min
Mounting holes
Use black installation
screws supplied
34 CLEANING YOUR OVEN DOOR Built-in Cooking
B
D (200mm)
C (581mm)
(893mm)
Flush fit
section view
34 INSTALLATION Built-in Cooking