User manual

CARE & MAINTENENCE
WARNING
IMPORTANT: The hood must always be disconnected from the
electricity supply before beginning any maintenenace work.
Changing the halogen lamps
If halogen lamps need replacing, they must be replaced by
lamps with an aluminium reflector, never dichronic lamps to
avoid unnecessary overheating in the lamp holders.
Ensure that the appliance is switched off before carrying
out maintenance to avoid any possibility of electric shock.
CAUTION
When handling lamps hold with a cloth or gloves to ensure perspiration
does not come into contact with the lamp as this can reduce the life of
the lamp.
User manual_CS910CS 28/11/2012
TROUBLESHOOTING GUIDE
PROBLEM REMEDY
The cooker hood will not start
Check that the hood is connected to an electrical supply
Check that a fan speed has been selected
The cooker hood is not working
Check that the fan speed is set high enough for the task
The grease filters are clean
The kitchen is adequately vented to allow the entry of fresh air
If set up for recirculation, check that the charcoal filter is still effective
If set up for extraction, check that the ducting and outlets are not blocked
The cooker hood has switched off
during operation
The safety cut-out device has been tripped – turn off the hob and wait for the device to reset.
If the hood has been installed below the heights indicated in the installation instructions the
motor will cut out frequently which will damage the hood
If you have completed all of the above checks and are still experiencing difficulty, please contact your local Electrolux
Service Centre.
AR150RC
AR150F
AR610CF
AR910RK
AR150WV
AR610FS
OPTIONAL DUCTING ACCESSORIES
Part Numbers Description
AR150RC 150mm G/Bond Roof Cowl
AR150F 150mm G/Bond Flue 1200mm
AR150WV 150mm Wall Vent & duct
AR910RK Recirculating Kit (150-120mm reducer,
T-piece & carbon filters
AR610CF Replacement carbon filter
AR610FS Stainless steel exhaust cover extension 1200mm
9
10