chef 900 Glass Canopy Installation and Operation Manual There is a fire risk if cleaning is not carried out in accordance with the instruction.
Accessories Use 125mm round exhaust ducting for best performance. When using flexible duct always install duct with the wire helix pulled taut to minimise pressure loss. Try to keep exhaust duct short and straight. Keep bends in the exhaust duct to a minimum. Do not reduce the size or restrict exhaust duct.
Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. COMPONENTS LIST 277 1 body assembly with grease filter 1 telescopic flue cover set 2 cover flue mounting brackets 1 instruction book 1 plastic bag containing screws for fixing telescopic flue covers 1 plastic duct transition: oblong to round 316 435(max) A COMPONENTS NOT INCLUDED Fixings required to attach cover flue mounting brackets to wall.
1 3 4 2 A 5 Important : Rubber washer to be assembled against glass 4
6 7 8 9 10 11 Ceiling 3mm 5
IMPORTANT WARNING FOR EXTRACTOR HOODS WITH HALOGEN LAMPS If the halogen lamps need replacing, they must be replaced by lamps with an aluminium reflector, never dichroic lamps, to avoid unnecessary overheating in the lamp holders. THE MANUFACTURER WAIVES ALL LIABILITY FOR FAILURE TO OBSERVE THE INSTRUCTIONS FOR THE APPROPRIATE INSTALLATION, MAINTENANCE AND USE OF THE EXTRACTOR HOOD.
NOTE: This product is fitted with a safety cutout device. If the cooker hood is installed to close to the cooktop, flambe cooking, operating the cooktop without cooking utensils and blocked filters may activate the safety cutout device. If the hood stops during operation, correct the faults and allow time for the safety cutout device to reset, the cooker hood will then function correctly. Do not operate cooktop without pots/pans. Do not flambe under cooktop.
p/n: 0342-001-594, issue: B 2012-10 8
