Use and Care Manual

3
• Before use, please check the power cord, plug, fine strainer, auger, juicer body
and other parts for any damage. Do not use the product if any damage is found.
Contact our customer service department.
• During operation, do not put fingers or sharp objects directly in contact with
rotating parts such as the auger, etc.; do not use any object to replace the
pusher. Keep eyes away from close contact with the juicer.
• The ingredients should be cut into small pieces so that they can be put into the
inlet of the juicing body. Remove any seeds, thick skin, or hard shells before
processing.
• Do not force ingredients through the juicer. If they do not go easily through the
chute, cut them into smaller pieces and try again.
• It is normal for the fine strainer, juicing body cover, auger and other parts to be
stained after juicing certain fruits and vegetables. It does not affect the quality of
the food or be harmful.
• The product is equipped with an intelligent protection chip, for automatic shutoff
after 20 minutes of continuous work. After automatic shutoff wait 20-30 minutes
to cool the unit before using again. This method is conducive to extending the
service life of the product.
• The product has a current limiting design. When processing harder ingredients,
the motor go into locked-rotor mode and the current will increase. Should the
current exceed 2A, the machine will make a "tick" sound and the motor will shut
down. This protects the motor from over-heating and extends the service life of
the motor.
• If the motor stops automatically due to current limiting protection or locked rotor
during operation the motor should be allowed to cool. After cooling set the
power switch to "REV" state, and the ingredients should be withdrawn. It is
recommended to use "REV" to clean up the ingredients in the auger before
continuing use. This method is to protect the motor. After cleaning shut the
machine and let it cool prior to using again.
• After use, please wait until the motor and auger stop rotating and make sure
that the power is disconnected before removing the removable parts of the
machine.
• Do not use hot water over 176°F/80°C or a microwave oven to clean any part of
your juicer. Parts and materials in contact with food ingredients are in line with
food hygiene certification, clean, hygienic, and reliable.
• Do not use steel wool, abrasive cleaner, or corrosive liquid (e.g. petrol or
acetone) to wash this product.
• This product is only applicable to individual or home application.
• This product is a Class I appliance. The grounding wire of the socket must be
well grounded.
• If this product needs to be repaired during use, please contact our Customer
Service Department. Be sure not to take apart or repair the product by yourself
to avoid risks and void the warranty.
SAVE THESE INSTRUCTIONS