Instruction Manual

magazine push the magazine release lever forward and swing the magazine

down while pushing the magazine release lever.

Dust Cover Release Latch: Located in back of receiver above stock. If the

detent is depressed and the latch is depressed, the upper receiver dust cover

can be removed for disassembly. See disassembly section of manual.

Dust Cover Release Latch Detent: Located on upper receiver release latch.

Round button that must first be depressed before latch is depressed.

Bolt Catch: Located by trigger guard. To use the Bolt Catch move the safety

to the off position and pull the bolt to the rear and then push the Bolt Catch up

so that it engages the bolt and holds it in the rear position. Now release the

bolt and it should be held in place by the Bolt Catch. To load a gun using the

Bolt Catch simply lock the bolt back as directed above, insert magazine as

directed above. Then pull the bolt handle to the rear and release and the bolt

handle and the bolt will strip a round from the magazine. Immediately move

the trigger block safety to the safe position after a round has been stripped

from the magazine.

Gas regulator: Located on the front of the gas tube. The gas regulator has

four positions. The four dots on the front relate from smallest to largest,

smallest dot is no gas/closed, next dot is for 30% of the gas, the following dot

is 60% and the largest dot is for full gas transfer. The dot should line up with

the detent and the regulator should begin from the completely screwed in

position and then backed out to the correct position.

INFORMATION FIGURES

Direction for Assembly

The Cheetah12 comes fully assembled. All you will need to do is remove the

wrapping, clean the protective oil from the gun and insert the magazine.

To load your Shotgun

1. Make sure the shotgun is pointed in a safe direction at all times, the safety

is engaged, and never allow fingers or objects to contact trigger.

2. Do not load shotgun until you are ready to fire.

3. Remove magazine if it is not already removed

4. Do not disengage the safety.

5. Make sure the ammo that you are using is the correct size and gauge. The

receiver is marked with the gauge/chamber size or caliber, shotgun barrels

marked 3" will also use 2 3/4" or 3" shot shells.