Instruction Manual

7
W A R N I N G
If there is any reason to suspect that a bullet or projectile is obstructing the
barrel, immediately unload the shotgun (See Unloading Instructions) and
check the chamber and the bore. A bullet may be lodged some distance down
the barrel where it cannot easily be seen. Check the bore by using a cleaning
rod to pass through the barrel. If a blockage is in the bore, DO NOT ATTEMPT
TO SHOOT IT OUT WITH ANOTHER CARTRIDGE, OR BLOW IT OUT WITH
A BLANK CARTRIDGE OR A CARTRIDGE FROM WHICH THE BULLET HAS
BEEN REMOVED. SUCH TECHNIQUE(S) CAN GENERATE EXCESSIVE
PRESSURE, DAMAGE THE SHOTGUN AND CAUSE SERIOUS PERSONAL
INJURY. If the blockage can be removed with a cleaning rod, clean any
unburned powder grains from the bore, chambers & mechanism before
resuming shooting. If the blockage cannot be dislodged by tapping it with a
cleaning rod, take the shotgun to a gunsmith.
WARNING (Mechanical Malfunctions)
STOP SHOOTING IMMEDIATELY AND UNLOAD YOUR SHOTGUN if your
shotgun develops: a mechanical malfunction; binding or stoppage; spitting
powder/gas; a cartridge primer is punctured; a cartridge case is bulged or
ruptured; or the sound on firing does not sound quite right. Do NOT try one
more shot but unload your shotgun and take it and the ammunition to a
qualified gunsmith or send it back to SDS Imports LLC for examination. Do
not assume that the shotgun is empty merely because you checked the
chamber. You must also check the bore for any fired shot or wad jammed
inside the barrel.
External Control Parts:
Trigger Block Safety: Located on receiver above trigger, pivot style. When
moved to the full up position blocks trigger movement. When in the lower
position trigger is fully exposed and free to move and the shotgun will fire if
trigger is pulled!! Do not disengage safety unless you are ready to fire the
shotgun. (Safety Engaged - Trigger Covered and Blocked and is blocked from
full travel; Safety Disengaged - Trigger is fully exposed and the trigger has full
travel...MAKE SURE YOU UNDERSTAND HOW THE SAFETY WORKS
BEFORE YOU LOAD OR USE THE SHOTGUN)
Trigger: Located in the trigger guard with safety disengaged and trigger pulled
to the rear the shotgun will discharge.
Bolt Cocking Handle: Located on left hand side of the shotgun protrudes from
bolt used for pulling bolt rearward.
Magazine Release Lever: Used for insertion or removal of the magazine. To
insert the magazine engage the front lug of the magazine with the magazine
lug located in the front of the magazine well. With the lugs engaged you should
be able to swing the magazine up into the locked position. To remove the