Instruction Manual

11
4. Pull the bolt back to the rear via the bolt handle and then release the handle.
The bolt will strip a round from the magazine and insert it into the chamber.
If the bolt doesn’t fully close don’t force it closed. Follow unloading
instructions if bolt doesn’t fully close.
5. When you are ready to fire pull the trigger to the rear and then release it.
You may then pull the trigger again if you wish to fire another round.
6. If the shotgun stops firing due to failure or full use of ammunition follow
unloading instructions below.
To Unload Shotgun
1. Make sure that gun is pointed in safe direction and engage safety, if
not already engaged. Never allow your finger or any object to come in contact
with the trigger during the unloading operation...
2. Remove the magazine by pushing the magazine release lever forward
until it touches the body of the magazine, while keeping the release lever in
the forward position swing the magazine forward and out of the receiver.
3. With the magazine removed move the bolt block safety to its lower
position, slide the bolt to the rearward position via the cocking handle and
inspect the chamber to be certain the shotgun is empty and free of debris and
then re-engage the bolt block safety so that it is holding the bolt in the rearward
position. If there was a spent or unspent cartridge in the chamber it should
have been ejected. If there is a cartridge stuck in the chamber and it did not
come out when you moved the bolt to the rear, obtain a cleaning rod and push
the cartridge out backward.