Installation guide

Before you begin, if this CheckVideo device will be monitored by a central staon, please contact the central staon for a username and password on their
exisng CheckVideo account. If this device will be self-monitored, you will be creang a CheckVideo account in Step 4.
Conrm that you have the equipment you’ll need and a network that meets system requirements.
Equipment
• CheckVideo Gateway
• CheckVideo Gateway power supply: 9-12V DC, min 1.4 amp
• Cabling for each camera being installed.
• Ethernet (Cat-5 or above) cable to connect the CheckVideo Gateway to the network
• Computer or laptop with broadband access (see Network secon below)
(Oponal:)
• 8 pin Phoenix connector to integrate sensor wires to either the digital input or digital output contact on the CheckVideo Gateway
• Monitor for viewing live video during camera setup. This can be a TV connected to a CheckVideo Gateway monitor connector with a BNC to RCA
cable.
• UPS power supply
• USB storage device: 2 GB to 1 TB capacity, with at least 500 MB available
Step 1 Check Equipment and Network
page 2CheckVideo Gateway for Broadband Networks Installaon Guide
Network
Once you are sure you have the equipment you need, conrm that the network where you will be connecng the CheckVideo Gateway meets these
requirements:
• Acve broadband Internet connecon with an upload speed of at least 512 kbps or higher
• If you have an acve rewall, it cannot block inbound/outbound trac on ports 123 (used for network ming), 80 (HTTP), or 443 (HTTPS).
• DHCP enabled
• Access to router conguraon (may be required)