Installation guide

Step 6-3 Dene Nocaon Methods by Camera (connued)
page 18CheckVideo Gateway for Broadband Networks Installaon Guide
Figure 30 Select Nocaon Method secon, User Nocaon Methods area
The user name and nocaon methods that you supplied in Step 4-1 and 4-2 (see
pages 6 and 7) automacally appear in the Users list (see Figure 30).
Select any user(s) who should receive nocaons for this camera. Then use the
drop down box under Nocaon Method to choose the desnaon and format of
their nocaons.
Select Digital Output if you want the CheckVideo Gateway to trigger an external
sensor when a behavior event occurs. For this to work, you must use an 8 pin
Phoenix connector to integrate sensor wires to the Digital Output contacts on the
CheckVideo Gateway (Figure 31).
The Advanced Analycs seng controls whether the system will apply standard
analycal pre-ltering to events that are sent to output contacts. This pre-ltering is
helpful in improving event detecon accuracy. It does, however, add a few seconds
of lag me for events to be reported. If you are using the Digital Output feature and
nd this lag me to be unacceptable,you can switch Advanced Analycs to O.
If selecng Digital Output, you can set a Closure Duraon, which determines how
long a parcular output contact closure eect (e.g., a strobe) lasts.
Click the Save and Return to Dashboard or the Save and Congure Another Camera
buon.
Figure 31 Digital Output contacts on CheckVideo Gateway
Digital Output contacts