Installation guide
Step 3 Seng Up the Gateway for Mobile Broadband Networks
page 4CheckVideo Gateway for Mobile Broadband Networks Installaon Guide
1. Aach the antennas to the Franklin Module. The antenna with the white stripe
at the base should be on the le when looking at the front of the device (see
Figure 3).
2. Extend the ps of the antennas outward from the Module. There should be a
good distance between the ps (see Figure 4), but not so great that they are
at).
3. Connect the USB cable between the USB port on the Gateway back panel and
the USB port on the front of the Franklin Module (see Figure 5).
Note: The Gateway has 32 GB of onboard storage that it uses to connuously
record DVR video. You can add addional storage through an external storage
device aached to a USB hub. See the Appendix for more informaon.
4. Connect each camera’s video cable to a camera port on the back of the
Gateway.
5. Plug in the power to the Franklin Module (12V, 1A).
IMPORTANT: Do not use the Gateway’s power supply (which is larger) to
power up the Franklin module. Doing so may seriously damage the module.
6. Plug in the power to the Gateway (9V, 1.66 A).
7. Wait a few minutes for the power light on the front of the Gateway to ash
rapidly.
8. When the ashing slows to one second per pulse, proceed to the next page.
Note: Although designed to operate over a cellular network, the Gateway can also
connect to the Internet via its Ethernet port. If an acve Internet connecon
is established over Ethernet, the device will use this connecon and not 3G.
Figure 5 USB Port Locaons
Figure 3 Antenna posions
White
Stripe
Figure 4 Antennas spread outward
Franklin
Module