Installation guide

Before you begin, if this CheckVideo device will be monitored by a central staon, please contact the central staon for a username and password on their exisng
CheckVideo account. If this device will be self-monitored, you will be creang a CheckVideo account in Step 5.
Conrm that you have the equipment you will need.
Included in the CheckVideo Gateway for Mobile Broadband Networks Kit:
• CheckVideo Gateway for Mobile Broadband Networks with Franklin® 3G S600C Module
• CheckVideo Gateway power supply (9V, 1.66A)
• Franklin 3G Module power supply (12V, 1 A)
• Franklin 3G Module antennas (2)
• USB 2.0 Cable
• Scker displaying MEIDs for the Franklin 3G Module and Serial Number (SN) for the CheckVideo Gateway (see page 11)
• 8 pin Phoenix connectors (oponal, for digital input/output contacts)
Required, but not included:
• Sprint 3G Network Access. Signal strength greater than -84 to -86 dBm (e.g., -85 dBm, -50 dBm, etc.) is required to receive rmware updates and stream
live video
• Up to four xed, analog NTSC/PAL cameras
• Computer with Microso Internet Explorer or Mozilla Firefox (required for inial registraon and conguraon)
Oponal:
• Monitor for viewing Received Signal Strength during setup. This can be a TV connected to a CheckVideo Gateway monitor connector with a BNC to RCA
cable.
• 8 pin Phoenix connectors for digital input/output contacts (included in kit)
• Uninterrupble Power Supply (UPS)
• USB storage device for expanded storage (up to 1 TB). This will require an externally-powered USB hub. If using a UPS power source, the same power
source should be used for the enre CheckVideo soluon (i.e., the CheckVideo Gateway, USB hub, Franklin 3G Module, storage device, and cameras). For
more informaon, see the Appendix on pages 23-24.
Step 1 Review Requirements
page 2CheckVideo Gateway for Mobile Broadband Networks Installaon Guide