Installation guide
Step 6 Add CheckVideo Gateway
page 11CheckVideo Gateway for Mobile Broadband Networks Installaon Guide
Note: The device is shipped with a scker
with two “MEID” numbers and the same
CheckVideo Serial Number that you use to
register the CheckVideo Gateway. The MEIDs
are for the Franklin Module, and could be
needed when troubleshoong an issue with
cellular connecvity. Do not discard this
scker. Instead, we recommend you ax it to
the Franklin Module or some other surface.
On the CheckVideo Dashboard, click Devices > Add a Device to register your
CheckVideo device.
Enter the serial number (located on the boom of the CheckVideo Gateway) into
the Serial Number eld (Figure 21).
Note: The name of the physical locaon for a CheckVideo device is
recommended (e.g. “Oce Camera”). You can change this name later.
Click the Test Device buon.
• If the test is successful, you will receive a Congratulaons message (Figure
22). The CheckVideo Gateway lights should stop blinking and the power
light should remain green, conrming that communicaon between the
CheckVideo Gateway and CheckVideo Portal has been established.
• If the test fails, you will be presented with a web page containing a series of
quesons designed to help you idenfy the potenal cause and troubleshoot
the situaon. If necessary, contact Support.
Once you have completed a successful CheckVideo device test, connue with
device registraon by clicking the “Next I want to” buons.
Figure 21 Device Serial Number
Figure 22 Congratulaons message, displayed upon successful CheckVideo device test