Installation guide

11
7. Click the Security tab to select options to customize data protection settings.
Trigger Receiver Server URL or IP - Enter the IP address or URL of the VideoAlert.net server
(69.20.70.164) or (www.videoalert.net) for the Gateway to send video to the VideoAlert.net server
when triggered.
Trigger Output - When the camera detects moving objects, or one of the (4) trigger inputs is activated,
the trigger output is activated, which may be used to trigger a zone on a security system, etc.. Enter
the duration of the trigger output signal (in seconds)., and the camera will continue to trigger the
device for the length of the time specified. Note: The trigger output signal is sent each time the
Manually Activate Trigger Output button is clicked.
LAG time to Start Guard - Specify the exit delay time (in seconds) allowing the exiting of the protected
area.
Activate Security Function - Click the radio button to select the Security Function type, either
Always or Daily. Select Always to enter security mode when the Trigger In or Motion
Detection functions are activated; select Daily to enter security mode at the specified Video
Gateway Internal Time (in 24-hour military time). See the Main tab, "Video Gateway Internal
Time" for more information.