User's Manual
Table Of Contents
- 1.0 INTRODUCTION
- 2.0 GENERAL DESCRIPTION
- 3.0 Quick Connect Interfaces
- 4.0 System Hardware
- 5.0 SPECIFICATIONS
- 6.0 USING DMS TO APPLY SOFTWARE SETTINGS
- 7.0 POWER SUPPLY REQUIREMENTS
- 8.0 DEVICE LABELING
USER'S MANUAL, NP10, NP20, NG10 (ALL NEO SYSTEM MODELS)
CHECKPOINT SYSTEMS, INC. FOR EXTERNAL USE
Document No. 10071753 Rev. 02 Page 23 of 28
5.10 RFID Reader
Mechanical specs:
PCB Layers: 8
PCB Materials: FR4
Dimensions: 225.2mm x 170mm (approximate outside dimensions) [8.87 x 6.69in]
Electrical Specs:
DC Power Input: +12V DC
Regulated Outputs: N/A
RF (UHF) Antenna Outputs: 4 SMA Female
Other Connector Types: RJ-45 (1), RS-232 Serial port for "Service".
B2B connector (1): 2 x 8 Header PCB-mount (from Hub Board)
5.11 Environmental
All the internal electronics shall meet or surpass the listed environment specifications:
Operating Temperature: 0° to + 60° C
Non-Condensing Relative Humidity: 5% to 95%