User's Manual
Table Of Contents
- 1.0 INTRODUCTION
- 2.0 GENERAL DESCRIPTION
- 3.0 Quick Connect Interfaces
- 4.0 System Hardware
- 5.0 SPECIFICATIONS
- 6.0 USING DMS TO APPLY SOFTWARE SETTINGS
- 7.0 POWER SUPPLY REQUIREMENTS
- 8.0 DEVICE LABELING
USER'S MANUAL, NP10, NP20, NG10 (ALL NEO SYSTEM MODELS)
CHECKPOINT SYSTEMS, INC. FOR EXTERNAL USE
Document No. 10071753 Rev. 02 Page 17 of 28
24V Power Input
Inside NEO: +24V = White Cable (this pole of the Orange Connector has the Black stripe)
NEO
side
From
PSU
The power connection is a "tool less" connector (only wire strippers/cutters are needed to prep the wire
leads, no screw driver is required).
If the provided connector fails during use, the FS Technician may install the DC power using a UL-
approved wire connector junction such as 2-Position terminal block (CKP P/N 7155630) or equivalent.
Insulated connectors with a locking lever are also common (approved for use so long as they meet
local/national code for low voltage wiring and have UL-approval).
4.7.4 Power Supply
The Power Supply is part of the system. See section 7.0 for all Power Supply Requirements
.
+24V DC
GND
GND
+24V DC