Installation Manual

PX/QX with Coupler Installation Manual Version *61
5. Click Apply
to complete the setup. A “Switch settings successfully set” message box will
come up. Click OK and Close.
6. Go back to the “Network View” window, and expand the network device level. The
device names under Antenna have been changed. Shown in Figure 27 Single Aisle Setup
Completion. This confirms the success for setting the PX/QX with Coupler operation
mode.
Figu
re 27 Single Aisle Setup Completion
Antenna Tuning
Please follow a separate document “PX/QX with Coupler Tuning Guide to complete this task.
Multi-Aisle Setup
The difference between a multiple aisles system and a single aisle system is that there is a master
ais
le in the multiple aisles system, and the rest aisles are the sub master systems. Therefore, in
addition to setup the PAB/SAB (coupler), it needs to setup the master/submaster configuration.
Therefore the steps involved in a multiple aisles system are:
1. Make a new DMS connection – for new installation
2. Setup the aisles as PAB/SAB (coupler) operation mode
3. Setup Master and Sub Master aisles
4. Antenna Tuning
Step 1, 2 and 4 are the same process as described in Single Aisle Setup.
Step 3 Setup Master and Sub Master aisle.
There only one master antenna in a multi-aisle system. Remaining pedestals are set to submasters.
1. Select the master antenna from the network view
2. Click Configure Settings on the right side.
3. Select Switch Settings from the Configure Settings window, then, click Next.
4. Click the “Band” tab, and select the Master from the Master/Submaster selection box.
5. Click Apply. A success setting message box will come up. Click OK. Then, click Close
to return to network view.