Installation Manual

PX/QX with Coupler Installation Manual Version *61
C H A P T E R
6
SY
ST EM CO NFIG UR AT IO N VI A DM S
Over
view
This chapter reviews how to configure 3G Trend/Liberty PX and 3G Plus/Liberty QX PAB/SAB
sys
tem using DMS. Antenna tuning including coupler jumper setting are covered in a separate
document “3G Trend/Liberty PX and 3G Plus/Liberty QX PAB/SAB Tuning Guide”. Please
follow this tuning guide to optimize the system performance after completing the system
configuration.
Note: Please use DMS version 1.5.8 and later. TR4026 firmware version must be V46.00 and
later.
System Setup Using DMS
PX/QX with Coupler systems run with firmware version 46 and later. It requires DMS tool
ver
sion 1.5.8 and later version.
Single-Aisle setup
The Single Aisle Setup process consists of following steps:
1. Make
a new DMS connection – for new installation
2. Setup the aisle as PAB/SAB (coupler) operation mode
3. Antenna Tuning
Make a New DMS Connection
1. Connect the service PC laptop to a TR4026 board in a PAB
2. Launch the DMS program (version 1.5.8 and later)
Note: Please refer DMS User’s Guide for help in using DMS tool.
Figu
re 20 Login DMS